Installing The Hp 10314D In The Hp 10269C - HP 10314D User Manual

Installing the
HP 103140 in
the HP 10269C
Caution
f,
Caution
f,
The HP 10269C General Purpose Probe Interface routes the signals
from the HP 103140 Preprocessor Interface and provides the correct
mechanical connections for the logic analyzer probes. To install the
HP 103140 in the HP 10269C:
1. Install the HP 103140 Preprocessor Interface on the underside
of the HP 10269C General Purpose Probe Interface Pod (see
figure
1-2).
Care must be used when handling the preprocessor interface to avoid
damaging the preprocessor interface cable. Avoid bending, twisting,
making contact with
sharp
edges, and other mechanical stress which
may damage the cable.
2. Insert the metal tabs of the preprocessor interface card in the
slots of the
pod.
3.
Connect
the two internal
pod
cables to the preprocessor interface
card ·
4. Gently fold the preprocessor interface card into the pod and
fasten the cable end of the preprocessor interface card to the pod
. with the two captive screws on the preprocessor interface card.
To prevent equipment damage, remove the power from both the logic
analyzer and the target system whenever the preprocessor interface or
microprocessor is being connected or disconnected.
Setting Up the HP 103140
1-6
HP 103140
80386DX Preprocessor Interface