Table of Contents
Advertisement
10314E02
HP 103140
Note . •
5. Place the microprocessor in the ZIF socket on top of the
microprocessor connector.
The ZIF socket on the top of the microprocessor connector allows you
to easily load and unload the microprocessor without damaging the
device or the microprocessor connector. However, this socket does
increase the capacitive load on the target system.
Heavily loaded systems may not operate properly with this additional
capacitance. If this
is
the case, remove the ZIF socket from the
microprocessor connector and carefully install the 80386DX directly
on the microprocessor connector.
-
LEVER
INDICATES
PIN A1
A1
- - PIN PROTECTOR
SOCKET
Figure 1-3. Installing the Cable in the PGA Socket
80386DX Preprocessor Interface
Setting Up the HP 103140
1-9
Advertisement
Table of Contents
