Electrolux ED30S Instruction Manual page 14

25 electrolux cleaning and maintenance
Cleaning and maintenance
To avoid accident, cut off the power
supply before operation according to
the following instruction.
The machine had been disinfected
before departed from factory. Cleaning
the dispenser prior to installing a full
bottle of water for the first time.
Cleaning and draining instructions:
1. Making sure the power switch in the
0(off) position and unplug the water
dispenser before cleaning.
2. Twist out the two screws, then take
down top cover, cold tank cover and
separator.
3. Fill 0,6 gallons pure water into cold
tank to clean it.
4. Place a large water bucket beneath
the drain outlet which on the back of
water dispenser, then, remove the
drain cover and drain the water.
5. Reposition the drain cover, separator,
cold tank cover and top cover after
draining. Ensure the pipe and wires
are connected properly, then you can
use the machine normally.
Attention
The cleaning must be under the guidance of professional staff.
The dispenser heats water to a temperature of approximately 85°C. It can
cause severe burns. Please operate it carefully.
Sanitizing
The machine should be disinfected
with disinfectant separately bought
from drugstore or marketplace
according to the instruction manual
of the disinfectant and then clean it
with water (see cleaning and
draining instructions).
Generally this should be done every
three months.
To remove mineral deposits
Mix 1 gallon of water with half
pound of citric acid crystals, inject
into the machine and make sure the
water can flow out of the hot water
tap. Switch on the power and heat it
about 10 minutes, 30 minutes later,
drain off the liquid and clean it with
water two or three times. Generally
this should be done every six
months.
Never disassemble this machine by
yourself to avoid risk of damaging
machine.
cleaning and maintenance electrolux 26