Huawei FusionCharge AC User Manual page 6

1
Opening the Charger
Read the installation precautions before the
installation.
1. Push the rear cover downwards.
2. Separate the charger body from the rear cover.
1
2
8
2
Securing the Rear Cover
Ensure that the installation surface is solid enough
to hold the charger. It is recommended that the
wall have a bearing capacity of at least 100 kg. Do
not drill holes on the rear cover. Otherwise, the
rear cover may be damaged.
1. Place the rear cover on the wall, keep it horizontal,
and use a marker to mark the hole drilling positions
on the wall.
2. Use a hammer drill to drill holes on the wall at the
marked positions, and place wall plugs into the holes.
(Insertion depth: 50 mm; φ10)
3. Use wall-mounting screws to secure the rear cover to
the wall. (Use an M6 Phillips screwdriver with a torque
of 1.4–1.6 N·m.)
Level
Mounting hole
Recommended:
x 4 130–140 cm
above the ground
3
Cabling in the Rear Cover
1. Switch off the upstream RCBO.
2. Use scissors to cut the rubber covers to fit the cable size. Rubber covers should tightly hold cables to ensure
sealing effect.
3. The cable stripping template is printed inside the carton. Use a wire stripper to strip the power cable based on
the template.
4. Select an appropriate cord end terminal based on the cable diameter, and crimp the cord end terminal to the cable.
5. Connect the power cable through the cable inlet based on the actual cable route. Squeeze the cable rubber
cover in the cable inlet. (If the cable diameter is 22±1 mm, you do not need to squeeze the cable rubber cover
in the charger. Attach it to the charger enclosure.)
Ring 1
Ring 5 (15.0±0.5)
Ring 6 (16.5±1)
Ring 7 (18.5±1)
Ring 9 (22±1)
Cable diameters supported
by the rubber cover (mm)
Power cable inlets
Rubber cover
Communications Power cable
cable inlet inlet
Stripping template
Left cabling
Middle cabling
Right cabling Bottom cabling
9