Husqvarna BS 75 Operator's Manual page 13

To start the product
1. Start the dust collector.
2. Make sure that the start/stop and function selection
switch is in the "0" position and the product is
connected to the power supply.
3. Turn the speed control counterclockwise to the
lowest speed.
4. Turn the function selection switch to the "1" or the "2"
position.
Note:
The "1" position energizes the drive motor.
The "2" position energizes the drive motor and starts
the vibration motor.
5. Turn the speed control slowly clockwise to the
necessary speed.
1804 - 003 - 28.08.2023
To operate the product
WARNING:
of an unknown cause during operation,
immediately set the start/stop and function
selection switch to "0".
1. Make sure that the function selection switch is
set correctly for the operation. Without vibrations:
position "1". With vibrations: position "2".
2. Push the drive levers to move the product.
B
a) To move the product forward, push the forward
drive lever (A). The product moves forward at the
set speed.
b) To move the product rearward, release the drive
lever (A). When the movement stops, push the
rearward drive lever (B).
WARNING:
movement of the product is always
at maximum speed.
c) To move the product forward at maximum speed,
push the forward drive lever (A) and the rearward
drive lever (B).
3. Turn the speed control to adjust the set forward
speed during operation.
To operate the product near a wall
• To operate the product near a wall, adjust the
adjustable handle. Refer to
handle on page 11 .
If the product stops
A
Rearward
To adjust the adjustable
13