Table of Contents
Advertisement
Figure 3 600R Series Rear and Side View
1
2
3
4
5
6
7
8
9
Reset Button
The reset button can be used to reset the access point to factory default settings or turn off/on the LED
display.
Use one of the following methods to reset the access point to factory default settings:
To reset during normal operation:
n
Hold the reset button for more than 10 seconds while the access point is running.
l
Release the reset button.
l
To reset during power up, hold the reset button while the access point is powering up.
n
The system status LED will flash again within 15 seconds indicating that the reset is completed. The access
point will now continue to boot with the factory default settings.
To toggle the system status LED between "normal" (default after power on) and "off" mode, during the
normal operation of the access point, shortly press the reset button for less than 10 seconds.
4
|
Reset Button
Micro-B Console Port
E0 Ethernet Port (Orange)
E1 Ethernet Port (Orange and Blue)
E2 Ethernet Port (Blue)
E3 Ethernet Port (Blue)
E4 Ethernet Port (Red)
USB Interface
Kensington Lock Slot
Rev 03|August 2023
Advertisement
Table of Contents
