Access Point Installation - HP 600R Series Installation Manual

Remote access points
Table of Contents

Advertisement

Figure 5 Connecting Power Adapter to DC Power Port
Figure 6 Routing Power Cord

Access Point Installation

All Aruba access points should be professionally installed by a professional installer. The installer is responsible for
meeting applicable national and electrical codes. Failure to properly install this product may result in physical injury
and/or damage to property.
Tous les points d'accès Aruba doivent impérativement être installés par un professionnel agréé. Ce dernier doit
s'assurer que l'appareil est mis à la terre et que le circuit de mise à la terre est conforme aux codes électriques
nationaux en vigueur. Le fait de ne pas installer correctement ce produit peut entraîner des blessures corporelles et
/ ou des dommages matériels.
For indoor use only. The access point, power adapter, and all connected cables are not to be installed outdoors. This
stationary device is intended for stationary use in partly temperature controlled weather-protected environments
(class 3.2 per ETSI 300 019).
You can put the 600R Series access point on any flat surface such as a desktop.
Installing the SIM Card (For AP-605R Bundle Only)
To use the AP-605CM12 cellular module, you need to install a SIM card to the SIM card tray on the AP-
605CM12 cellular module. The SIM card tray has two SIM card slots - SIM slot 1 and SIM slot 2. At any given
Rev 03 | August 2023
|
7

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ap-605r

Table of Contents