Removing The M.2 2280 Solid-State Drive - Dell 0HRTG Service Manual

About this task
Steps
1. Place the solid-state drive into the thermal plate and install the single (M2x2) screw.
2. Slide and insert the tab of the solid-state drive into the solid-state drive slot.
3. Replace the single (M2x2.2) screw and tighten the single captive screw to secures the thermal plate to the palmrest.
Next steps
1. Connect the battery cable.
2. Install the base cover.
3. Install the SD card.
4. Follow the procedure in

Removing the M.2 2280 Solid-state drive

Prerequisites
1. Follow the procedure in
2. Remove the SD card.
3. Remove the base cover.
4. Disconnect the battery
after working inside your
before working inside your
cable.
computer.
computer.
Disassembly and reassembly 33