Attaching The Presser Foot Holder; Setting Up The Thread Spool Pins - Silvercrest 114197 Operation And Safety Notes

Attaching the presser foot holder

A
B
1
E
3

Setting up the thread spool pins

D
D
A
E
C
D
2
4
C
C
B
Important:
Turn the main switch (20) to off ("O")
when carrying out all the operations!
1. Install the presser foot holder
Raise the presser bar (A) by lifting the
two-step presser foot lifter (18) Attach
the presser foot holder (B) as
illustrated.
a
2. Inserting the presser foot
Lower the presser foot bar (B) until the
groove (C) is directly above the pin (D).
Lower the presser foot bar (A) as far
as it will go. The presser foot (a) will
engage automatically.
3. Removing the presser foot
Raise the presser foot.
p
Press the lever (E) gently towards the
front and the presser foot disengages.
4. Inserting the edge/ quilt guide (p)
As shown in the illustration carefully
insert the edge/ quilt guide (p) e.g. For
hems, pleats, etc.
The thread spool pins (C, D) serve to
hold the thread spools in place while
thread is being fed to the sewing machine.
To use the spool pin, pull it upwards. To
store it, push it down.
Note:
If you are using thread which tends to
wraps itself around the spool pin, put
the thread on the thread spool pin (C)
and guide the upper thread (A) through
the eye (B) in the thread spool pin (D),
see Fig. The eye (B) should point in
the direction of the thread spool.
Getting ready
GB / IE 77