Advertisement
Available languages
Available languages
The DC power unit <TP-009> is initially mounted in the set, and
no batteries are installed in the DC power unit < TP-009>.
Fit a suitable mains plug to the open end of the cable. If a 3 pin Plug is used
the EARTH
pin must not be connected.
Install the AC. power unit < TP-220 > in the set and connect the power cord
of the < TP-220 > to an AC OUTLET.
= REMOVING THE POWER UNIT
@ Remove the telescopic antenna from the antenna holder.
@Unlock the unit stopper in the direction of the arrow.
©Pull the power unit in the direction of the arrow to remove it while un-
locking the unit stopper.
< TP-220 >
AC OUTLET
(220V)
&
# INSTALLATION OF POWER UNIT
NOTE:
Install the power unit by the reverse procedure of removing the power unit. It
The
acy "indication
of the
FUNCTION
SWITCH
shows stand-by
in AC
is not necessary to operate the unit stopper @.
operation, "C) "shows "OFF" in DC operation.
—A1—
Advertisement
