Advertisement
OPERATING
THE
JOINTER
A/N CAUTION
: о Be sure to attach the safety cover before use.
Otherwise, the blade will be exposed
while
in rotation
which
may cause
an
injury.
o Set the cutting depth to "О"
before rotating the blade and confirm that the
safety cover functions
properly and smoothly
by sliding a piece of material
on
the
table
surface.
о lt is dangerous
to retract
the
material
while
cutting
because
the tip of the
blade
may
reject
the
material.
Never
retract
it.
о Use the standard
accessory
Pushing
Block to
Pushing
Block
|
,
feed
thin
or small
material
(Fig. 7).
Vertical
Lines
o Two
Vertical Lines marked
on the Guide
(Rip
Fence)
indicate
the limits of exposure
of the
x
blade.
=>
q
Рио
Ar
ө й
:
122
Д
кори
EN
Never
place your
hand
near this area.
No ж
° Do not store the shavings
at the bottom
part of the Chute.
In cutting
operation
while shavings
are stored, the chip-discharging
port will be blocked, and
it will cause
a blocking
with
the shavings.
о When
shavings
are blocked
inside of the chute, never
put your fingers
into the chip-discharging
port
(inside the chute).
Be sure
to switch
off, and
unplug
the machine
from
the power
supply
(plug sockect).
Then, take
out
the
jointer
section, take
out
the
chute, and
remove
the
shavings.
Advertisement
