Table of Contents
Advertisement
Input Configuration Screen
Use the Input Configuration screen to configure the source types that are connected to the ANT1 and ANT2 jacks.
1
Press
or
to navigate to the appropriate
fields.
2
Press
or
to select the type of inputs you
connected to the DST-3100.
Press
or
to highlight the Save and then
3
press SELECT.
Terrestrial Channel Screen
Now that you have configured the inputs, the Terrestrial Channels screen allows you to select the available channels for
your input source.
1
Press
or
to highlight Scan and then press
SELECT.
The receiver will scan for available channels
from the input source(s) that you configured in
the Input Configuration screen.
When the scan is complete, the screen will list
the channels and which antenna input they are
coming from (ANT1 or ANT2).
2
Press
to highlight the channel list if you need
to manually add or delete channels
3
Press
or
to highlight the desired channel
boxes (on the left side of the screen). Press
SELECT to add the highlighted channel. A blue
box with a checkmark indicates the channel has
been added.
To remove a selected channel, highlight the
desired blue box and press SELECT. The
checkmark will be removed and the box will be
gray.
4
After you have selected all desired channels,
press
or
to highlight Save and then press
SELECT.
Notes
• If you have not configured any inputs, the message below
will be displayed. To configure the inputs, select Inputs on
the Terrestrial Channels screen.
29
Advertisement
Table of Contents
