Kenwood 107VR Instruction Manual page 22

PRO LOGIC
hoy
CENTER
MODE
@ Press the SETUP key (remote control unit |.
only).
"SUB ON" o:
"SUB OFF" is
diselayed
© Set the sub-woofer to ON or OFF.
© Press the SETUP key to set the selection.
When the selection is set, the unit enters
the condition for "G@ Adjust the front
speaker balance".
Adjust the front speaker balance.
@ Ensure that the balance setup is dis- |
played. i
@ Adjust the front speaker (left & right) |
LEVEL "s
identical.
i To aecrease the a
; aa
ieft channe. sourd
C ~)
nght channel sound "7
the setup.
Atter this, the unit enters the condition q
for "G Adjust the volume level of each :
OPVR Er:
pla
Keys cr cantrals 10 De used ir tris operation
— Kimmo =
CPE rit Chi. Tae
POE Li Pepa afk.
The input sources are switched tn the following order:
1 NORMAL
| When the center speaker 1s a compact
speaker.
2 WIDEBAND : When the center speaker is a large speaker
3 PHANTOM
= When no center speaker is used
levels so that the left and right levels are '
© Press the SETUP key again to establish |
22 Setting the sub-wooter
EJ Adjusting the front speaker balance
Ai Adjusting the volume level of each speaker
G Adjusting the delay time
End of setup
To cancel setup in the middle, press the SETUP key repeatedly until the
setup mode is cancelled.
Each press switches the sub-woofer as follows.
F 1 SUBON : Sub-woofer ON
2 SUB OFF : Sub-woofer OFF
SURROUND
Aas, its AND de waikn al
!
Balance setup