Kenwood 107VR Instruction Manual page 9

ADZVR [En]
SURROUND 3 STEREO MEMORY indicatar
'nd:caio' iNdicato:
Source Direct
inaicator
bint Be acy Boats SURROUND 9 STEREO = ees
DSP indicate:
TAPE 2 irdicater oe = oS
TAPE 2
M.B circuit
IP CICaO"
ft
'i
ee
Broadcast pane
Imaicalors
madicata'
KENWOOD
Ure STARDB +
@ POWER key
Press to switch tne power ON and OFF
@ STANDBY indicator
© SRS 3D indicator
Lignts wren the SRS 3D system is ON
© SPEAKERS indicator
rights when the speakers are ON
O STEREO key
Press to turn the surround mode OFF
aa 3%:
GQDOLBY PRO LOGIC key ~_ 22
@ DOLBY 3 STEREO key 24
OSRS 3D key ~ 26
OINPUT SELECTOR knob
Rotate to select the input Source
@ VOLUME CONTROL knob
@ PHONES jack
Piug reagpnones inte
@ AUTO key
Press to seiect tne tuning mode from the
3.ts tuning and manua! tuning modes —._1?
Press and hac the AUTO key for more tnar
2 seconds 10 sw tch the VIDEQO1 dispiay to
arowrer 'nput display — 32
tus jack
About the ST TA NDBY indicator
——-N.B. ST: 7 Ht kH
Fe ) Nite
oe d:spay.
Input display,
Preset charne: display.
Surround mode dispiay
® SPEAKERS A/B keys
Press to select the A and/or B speakers
system.
@ DIRECT key — 18.
Press when tuning a broadcast station by
entering the digits of its frequencies
& MEMORY key - 19,
Press when registering a broadcast sta-
tlon in tne preset memory
> Numeric keys {1 to 0, +10}
@ BAND key
Press to sw.tch the broadcasting band
@ DISPLAY key
Press to switch the displayed information
between the surround mode display and
indut selector display. |
Press and hold the DISPLAY key for more
thar. 2 seconds to switch the display bright-
ness
= 17
@TUNING keys (Vv, A} ~ 17,
Press to select a radio station
€) TAPE 2 MONITOR key ~ 16,
Press to monitor the sound being re-
corded, etc.
AUTO tunirg/AUTO
wl indicator stereo reception indicator
@N.B. key ~_i4
Press to compensate for the insuffr-
ciency in the base sound.
@DSP LOGIC key
@DSP key
@ SOURCE DIRECT key
Press to listen to the source sound with 3
higher sound quality.
@ AV AUX (VIDEO) input terminals
Video input terminal.
@ AV AUX (AUDIO) input terminals
Audio input terminal
Tos ur-t has a STANDBY 'rdicator, tne lignting of whicn indicates tnat a small amount of current is Supplied to back up the internal memory of the unit.
This Status 1s 'eferred to as the standby mode of the unt in this mode, the power of the unit can be switched ON from the remote control unit.
Wiher tie unis
not? o be used tor a long perioa of t-™e, unpiug the power cord from the power outiet