Philips Electrical User Manual page 10

● Fixing the water heater: Lift the water heater, insert the mounting plate into the mounting hole on the back,
then �x and lock it in place using + shaped countersunk head self-tapping screws, make sure the installation is
secure before releasing it to avoid falling.
● Refer to (Figure E) to assemble the shower head. Determine its installation position, and use an impact drill (Φ
6mm drill bit) to drill two 30mm deep holes on the load-bearing wall according to the positions of the two
holes of the shower head holder and then �x it with self-tapping screws.
● Accessories installation: Connect the hose, shower holder, shower, �ow valve and other accessories as shown
in (Figure E).
CAUTION
● A seal must be used at the pipe interface. Water intake port and the shower head interface must be padded
with a �lter. A valve must be installed at the water intake (Valve to be prepared by user)..
Power cable
Hot water outlet
Hanging plate
Screw
Machine
Lower �xing hole
Figure D
Leakage protection
switch
Tee
Figure E
EN 7
Lock
NOTE: If the inlet and outlet of
the water pipe are already
equipped with a sealing gasket,
Gasket
there is no need to install this
sealing gasket again (the
braided pipe of this product is
Flow valve
already equipped with a sealing
gasket).
Gasket
Cold water outlet
Cold water inlet
Angle valve