Method Of Use - Philips Electrical User Manual

8.3 Method of use

CAUTION:
Notes before connected to the power:
● Check whether the leakage protection switch is installed in a suitable position and whether it can operate.
● The inlet valve (angle valve) must be opened �rst.
● Check whether there is any water leakage at each interface, and then turn on the appliance only when
water �ows out evenly from the water outlet valve.
● When taking a shower, please adjust the water temperature �rst and do not directly put any part of the
body under the water to avoid being scalded by hot water.
● Users are requested to maintain good habits: it is recommended to turn on the water before turning on
the power when start the device; when turning off, disconnect the power �rst and then turn off the water.
● Connected to power
When the power is turned on, the display screen will light up for 3 seconds, and the buzzer will beep once to
indicate that the power is turned on; After the display screen is fully light for 3 seconds, then display the
consumption power for 1 second then enters standby mode.
● Turn on the device
When there is no water at the water inlet, press "
key to set it, but the water heater does not work. In the power-on state, when the water �ow at the water inlet
reaches the start-up �ow, the machine starts to work.
● Operation
During the working process, you can press "+" or "-"key to adjust the setting temperature, and the buzzer will
beep once every time you press it as a reminder (the temperature setting range is 30 -55℃).
● Shutdown
Press the " " button to shut down and then turn off the water.
Introduction about the display
● Display the set temperature and outlet water temperature under normal conditions.
Fault code display: When a failure occurs, fault codes (F5, E4, E1, etc.) are displayed.
" button to turn on the device. You can operate any function
Figure F
EN 8