Method Of Use - Philips AWH1006/51 User Manual

8.3 Method of use

CAUTION:
Notes before connected to the power:
● Check whether the leakage protection switch is installed in a suitable position and whether it can operate.
● The inlet valve (angle valve) must be opened �rst.
● Check whether there is any water leakage at each interface, and then turn on the appliance only when
water �ows out evenly from the water outlet valve.
● When taking a shower, please adjust the water temperature �rst and do not directly put any part of the
body under the water to avoid being scalded by hot water.
● Users are requested to maintain good habits: it is recommended to turn on the water before turning on
the power when start the device; when turning off, disconnect the power �rst and then turn off the water.
● Turn on the power
After connecting the power supply, the display screen will be fully bright for 2 seconds, indicating that the power
supply has been connected, and the water heater will enter the standby state.
● Power on
Open the water valve，press the "
start up, and after displaying the current set temperature for 3 seconds, it will automatically switch to display the
current outlet water temperature, and the water heater will start heating .
● Operation
During the working process, you can press the "
you press the " " button or "
button or " " button continuously for 1.5 For more than 1 second, the temperature setting value increases or
decreases continuously, and the temperature setting value range: 30‒55°C.
● Power off
Press the " " button to turn off the machine and turn off the water.
Introduction about the display
● " " , Display temperature/Fault code
The normal display temperature of the water heater in Celsius is "°C".
The fault code display: When the water heater encounters a malfunction, it displays the fault codes (EC, HE, E5, E1).
● " ℃ " , Temperature unit
● " " , Protection state display
When the water heater is operating normally, it will be steadily lit to indicate the entry into protection state. When the
water heater malfunctions, it will �ash to indicate that the machine has encountered a fault. Please refer to the
"Troubleshooting" guide when the �ashing occurs.The fault code display: When the water heater encounters a
malfunction, it displays the fault codes (EC, HE, E5, E1).
● " " , Heating state display
Indicate whether the water heater is in working condition: when the characters are illuminated, it signi�es the
operation of the water heater; when the characters are not illuminated, it indicates that the water heater is not in
operation.
" button after water �ows out of the water outlet valve，the water heater will
"button or "
" button, the temperature will increase or decrease by one degree. Press the "
Figure F
EN 8
" button to adjust the set temperature. Each time
"