Level 1 and 2 Service Manual
Removing and Replacing the Plastic Chassis Housing
6881024B40-A
To Remove the Plastic Chassis Housing (PCH)
1.
Ensure the phone is off.
2.
Remove the battery door (see page 16).
3.
Remove the battery (see page 17).
4.
Remove the USIM (see page 19).
5.
Remove the front housing (see page 20).
6.
Remove the four screws holding the PCH in place and set aside for reuse (see
Figure 9A).
7.
Disengage the two snaps on each side (see Figure 9B).
8.
Disengage the snap located by the Planar Inverted F Antenna (PIFA) from the
Rear Housing (see Figure 9C).
A
B
Figure 9. Removing and Replacing the Plastic Chassis Housing
9.
Raise the top of the PCH assembly (see Figure 10D) to avoid damaging the
Display and PCH Flex connectors.
October 27, 2003
D
Disassembly
C
020822-o
23