Removing And Replacing The Camera - Motorola A920 Service Manual

Disassembly

Removing and Replacing the Camera

28
To Remove the Camera
1. Ensure the phone is off.
2. Remove the battery door (see page 16).
3. Remove the battery (see page 17).
4. Remove the USIM (see page 19).
5. Remove the Front Housing (see page 20).
6. Remove the PCH (see page 23).
7. Remove the transceiver board (see page 26).
8. Disconnect the camera's flex connector carefully grasping both sides of the
connector and gently pulling upward. Be careful to avoid damaging the flex
cable or connector.
9. Gently disengage the latch on each side of the camera and carefully slide it
away from the transceiver board.
LATCH
Figure 13. Removing and Replacing the Camera
To Replace the Camera
1. Align the slots on the side of the camera with the transceiver board.
2. Slide the camera into position on the transceiver board. The latches on each
side of the transceiver board lock the camera in place.
3. Carefully align the flex connector to the connector socket on the transceiver
board and press into position.
October 27, 2003
CAMERA
TRANSCEIVER BOARD
A920, A925
020832-o
6881024B40-A