Toshiba MW20FN1/R Owner's Manual page 18

Warning:
When playing OTS-encoded discs (unit), excessive noise may be output from the analog stereo iacke. To avoid possible
damage to the audio system, you should fake proper precautions when the ANALOG AUDIO OUT (L/R) jacks of the unit are
connected to an amplification system. To enjoy DTS Digital Surround
TM
playback, an external ,5.1 channel DT$ Digital
Surround T_ decoder system must be connected to the BITSTREAMIPCM AUDIO OUT iack of the unit.
MPEG2 sound
You c_n enioy motion picture and live concert OV[3 video discs v4th dynamic realistic sound by connecting an amplifier equipped v_ith
an MPEG2 audio decoder or MPEG2 audio processor:
"1
I Amplifier equipped with an I
MPEG2 audio decoder |
_Fo COAXIAL
l type digital
_udio input
| 75 _t coaxial cable
• Use DVD video discs encoded via
the MPEG2 recording system.
2 channel digital stereo
You can en}oy the dynamic sound ef 2 channel digital stereo by connecting an amplifier equipped with a digital audio input and speaker
system _fight and _eft_ront speakers),
Notes:
,, DO NOT connect the BITSTREAM/PCM AUDIO OUT jack of the unit to the AC-3 RF input of a Dolby Digital Reseiven This
input on your AN Receiver is reserved for Laserdisc use on{y and _s{nsempatible with the BITSTREAM,'PCM AUDIO OUT
jask of the unit.
• Connect the BITSTREAM/PCM AUDIO OUT jack of the unit to the "COAXIAL" input of a Receiver or Processor,
• Refer to the owner's manua_ Of the connected equipment as we{{.
• When you connect the unit to other equipment, be sure to turn off the power and unplug all of the equipment from the well
outlet before making any connections.
• The output sound of the unit has a wide dynamic range. Be sure to adiusf the receiver's volume to a moderate listening level.
Otherwise, the speakers may be damaged by a sudden high volume sound.
• Turn off the ampiitier before you connect or disconnect the unit's power cord. If you leave the ampliSer power on, the
speakers may be damaged.
18