Fujitsu DYNAMO 640SE User Manual page 10

Do's and Don'ts
m Never disassemble DynaMO 640SE under any circumstances.
= Never drop your DynaMO 640SE.
m Never turn your DynaMO 640SE over while in use.
Always ensure that the busy indicator light is off before turning
the power off.
Make sure the power is off before disconnecting any cables.
Remove the MO disk before moving your DynaMO 640SE.
m Never force the disk into the drive or insert a MO disk upside
down as this may damage the drive.
m Since a floppy disk is about the same size as your MO disk, be
careful to never insert a floppy disk into the DynaMO drive.
= Do not insert foreign objects into the drive.
Use only ISO-compliant 3.5-inch MO disks.
= Do not use your DynaMO 640SE in areas where dust, dirt,
extreme temperatures or moisture is present.
Troubleshooting
Although the DynaMO 640SE is designed to be highly reliable, you
may occasionally experience problems. This section describes problems
you may encounter when using your DynaMO 640SE. If you
experience problems other than those outlined below, contact your
dealer or Fujitsu Technical Support (in the US 1-800-626-4686).
The power indicator ,_ |s the Power Cord properly connected?
does not light up. Are you using the provided Power Cord?
Is the power on button fully depressed?
The computer does Is the power indicator light on?
not recognize the Is the busy indicator on?
DynaMO 640. Is the SCSI cable connected properly?
Is the SCSI ID selected properly?
Is the device driver installed?
Is the MO disk inserted correctly?
Is the MO disk formatted correctly?
You cannot insert Is the disk being inserted in the correct direction?
the MO disk. Has another MO disk already been inserted?
Is the green power on indicator lit?
You cannot eject the ._ /s the green power on indicator lit?
MO disk. Is the busy indicator lit (disk in use?)
Is software preventing the disk from being ejected?
You cannot record Is the green power on indicator lit?
data on the MO Are the cables properly attached?
disk. Is the MO disk write-protected?
Is the MO disk formatted?
Is the device driver installed?
7 USING DYNAMO