Special Functions - HP 5355A Operating And Service Manual

Model 5355A
Operation and Programming
Table 3-11. Diagnostic Modes and Special Functions
IN LOCAL operation the diagnostic modes listed below are obtained in numerical sequence by pressingthe gold MAN
FREQ and blue OFFSET FREQ keys simultaneously. Observe the display for the mode number listed below to determine
the diagnostic mode of the 5355A each time the keys are pressed. If diagnostic mode (1-10) is started in one column, the
sequence will stay in that column. Press reset on 5345A and set desired operational mode on 5355A to restart sequence.
In REMOTE operation, the diagnostic modes are programmed by use of the codes shown in Table 3-9.
MODE
- t sefond display
each sime
ftoid and Mu« key
is pressed '
0.4—1.6 GHz INPUT RF HEAD INPUT
Column 1 Column 2
* CW PULSE
DIAGNOSTIC
N
Displays 885.2 MHz self-check frequency
(synthesizer set to 1 GHz).
• Displays ratio of mea-
- NA sured pulse width to
: reference pulse width,.
. Displays reference
:c ( . ;NA ; f pulse width. :
Column 3
CW
Column 4
PULSE
- - NA '
Displays synthesizer frequency to 100 kHz
resolution.
Displays calculated N number. Ignore annunciator
and round to nearest integer. {-) sign means add IF.
Displays (A-B) counts Displays calibration
from synthesizer during factor. Ignore
N determinations, annunciator.,: -
_ r,~_ uispiays prescaic
* Displays measured ; Displays • A-B) counts DfSf
pulse width. \ from IF during N sure
' determination';' ' •• refe
frequency; i.e., input frequency Displays IF frequency. * Disf
ot roea-
/idth to
se width.
ays measured
; width.
Displays calibration . '.Displays reference
:zUozzzz NA
■■
factor.Ignore
■
NA f pulse width.
annunciator.
NA
, ** Ut —t
' ' "NA'-'- NA ' Displays IF3 during N
determination.
^ Manual mode frequency measurements with
synthesizer set to frequency entered in offset mode,
_ ,n
_ ^ Display's IF frequency produced by synthesizer
set to frequency entered in offset mode.
SPECIAL FUNCTIONS
i ,_The integer M in the equation fdispiayeti = M ♦ fmeasured± B may be entered. Go to OFFSET mode; M is
~ 1 ! the integer located in the second through fifth digits; 0001 to 9999.
i Iczz z: Measurements made are multiplied by M entered in mode 11. An offset may also be entered.
Bypasses 5345A SAMPLE RATE
"' r (Manual and Auto)
Disables calibration
All Modes
(Manual and Auto.-
' z:~P Both 13 and 14 above
hzz Unassigned (Will reset sequence)
VCO search at low gain. Used to adjust A5R10
■ ; ;; VCO search at high gain. Used to adjust A5R7
Bypasses 5345A SAMPLE RATE
(Manual and Auto?
Disables calibration
All Modes
(Manual and Auto)
Both 13 and 14 above
NOTES:
f Reference pulse width is measured during
calibration only.
* Pulse width measurements are displayed by
annunciators equivalent to time, as follows:
Display Time
kHz ns
MHz p,
GHz ms
3-25