Table of Contents
Advertisement
Mode! 5355A
installation
2-14.
HP-IB Interconnections
2-15.
HEWLETT-PACKARD interface BUS.,
HP-IB connector is provided in
interconnection of up to 15 (including the controller)
C/D HPdB cables. The HPdB system anowsin™
-'piggyback" connectors on
HP-IB compatible instruments. The H
cineie source without special adapters or
both ends so that several
®
be connected in virtually any configuration
switch boxes. System
""°,hlom.hecalculator(or other controller) toeverydevice
desired. There must, of course, be a pat
stacking more than three or four cables on any
operating on the bus. As ^
produces great leverage which
::: dTage t^V^nror ^urn^.l^st each connector is firmly (finger tight, screwed m
place to keep it from working loose during use.
CABLi U.O,H BESTBICOMS. l-g"
voBag. levels end timing
„t|| fgH ,o perform properly. Theretore. rvhen
a
The total cable length for the system must be less than or equal to 20 metres ,65 feet),
b
The total cable length for the system must be equal to or less than 2 metres (6,6fee.) trmes
the total number of devices connected to the bus.
C.
The total number of instruments connected to the bus must not exceed 15.
2-17.
5355A Listen Address
HP m instrument address selection switch. There are five
2-18.
The 5355A contains a rear
'
,
I
^
address. Instructions for
:rranSStrn ad^^^ at'^^deTin Section
of this manual along with
programming codes.
2-19.
HP-IB Descriptions
2-20.
A description of the HP-IB
P™^^HP-fB'concepT Additional information
mation is necessary if the user
'y^'.bfb.s is
available
in IEEE Standard 488-1975,
tnd^rDfta "interface for Programmable Instrumentation".
2-21.
Operational Check
2-22.
Operational c,neLK
Sect,oJtt^rr.ttn:trtrp\":ita^n?tvic^^
mation relative to warranty claims.
2-23.
PACKAGING FOR RESHIPMENT
2-24.
Original Packaging
container FRAGILE to assure careful handling.
2-2
Advertisement
Table of Contents
