Model 5355A
Operation and Programming
Umbilical connectors (5355A to 5345A). Provide
power connections from the 5345A to the 5355A
and interface the control and data lines between
the units.
Figure 3~2. Rear Panel Control and Connectors (Continued)
3-46.
KEYBOARD CHECK
3-47.
Check for proper operation of the keyboard and display by performing the procedures
listed in
Table 3-1.
Table 3-1. Keyboard Check
NOTE
Perform the preliminary procedures in paragraph 3-34 and connect a
5356A/B/C Frequency Converter Head to the 5355A prior to pro¬
ceeding. If a 5356B, Option 001 or 5356C is used refer to paragraph 3-17
for differences in frequencies displayed in steps 4 and 7 through 12.
STFP
PKOCEDURF
1
-ft 1*43A POV\FK
switch to ON
Ail 5355A key LEDs illuminate momerttarily.
1^'* "1 '
kev illurnmates. 5345A displays head code momentarily.
See paragraph 3-56.> 5345A displays all zeros.
2
0
:-
illuminates.
'
'■■■..
■ -
■ ^ • 1 ■ ■
key LED extinguishes. 5345A';displays all zerps^ except the'most
:yk.
df0t::
when pulse signal ts present (for
calibration rbu^
note in paragraph 3-33 for details.
3
Return to CW mode by
pressing
0^^^^
5345A''-dlsplaysi;a]l:''Zerbs;:\(;s^
4 ••
' Press
manual
Key LED ifiufninates..(S345A^:id^^
CHz for one second, then all zeros.
Turn manual mode off
by pressing
i_//
Key LED extinguishes.
6
_
«rset;-
• Press.^}^^;.-
Turn off offset mode by.
Key iEp;ll|uminates. 5345A displays-1.0CMOOOOOOO GHz.
Key LED extinguishes. 5345A displays;atf zeros';. •
3-12