Table of Contents
Advertisement
Model 5355A
Operationg and Programming
Table 3-2. Pulsed RF Measurements
Connect the CATE OUT connectoron the rear panel of the 5355A to the
CATE CONTROL INPUT connector on the rear panel of the 5345A,
using 10502A cable provided.
PROCEDURE
The 5355A key LEDs llbrninat^ momentarlfy.
key illuminates. 5345A
5345A display^: head
(See paragraph 3-56.) 5345A displays all
zeros.
Perform the preliminary
procedures in para¬
graph 3-34. Set the
5345A POWER switch
to ON.
LED illuminate. 5345A displays signal frequency.
Apply pulsed RF signal
SIGNAL LED and
to RF HEAD INPUT and
Table 3-3. Manual Measurements
The manual measurement mode decreases acquisition time (see
Table 1-1} and can be used if the input frequency is known within
50 MHz.
key illuminates. 5345A
LEDs illuminate momentarily.
Perform the preyminarv
procedures in paragraph
3-34. Set the 5345A
POWER switch to OH.
displays head code momentarily
Key LED illuminates. 5345A displays the low frequency listed in paragraph 3-17.
5345A displays selected number.
displayed number is
withirt 50 MHz of the
known input signal
frequency.
Key LED extinguishes,
Press and release
#111
VAN
Key
LEO
Hlumrnates. 5345A displays
itluminates. SIGNAL LED illuminates.
3-15
Advertisement
Table of Contents
