Table of Contents
Advertisement
MANUAL CHANGES MODEL 5355A (05355-90013)
SERIAL PREFIX OR
SERIAL NUMBER
CHANGES
Page 1-2, Table 1-1. Model 5355A Specifications:
All Serials
Maximum Input:
>Add two asterisks (*«) to "+5 dBm" for the 5356C.
>Add the following footnote:
** In Pulse Mode 1.5 to 5.0 GHz, 0 dBm (+5 dBm typical).
>Add two asterisks (**) to the "+15dBm" on all ranges
for the
5356c.
>Change the two-asterisk footnote to read as follows:
In Pulse Mode, OdBm (+5dBm typical)."
Page 1-3, Table 1-1, Model 5355A Specifications:
All Serials
>Delete the asteriskC*) next to 5355A, under PULSE MODE
column.
>Delete the Min Pulse Width, in the 5355A column, to IDOns.
>Delete, at bottom of page, "Specifications apply only to
external gating of 53^5/5355".
2132A
>Change the MAN MODE specification from "60ns" to "75ns" in
the area labeled "PULSE MODE" "Pulse Width" "MIN".
>Change the "PULSE MODE" "Accuracy" specification (lower
right-hand corner) from "(,08EXT GATE WIDTH)" to
"(.12/EXT GATE WIDTH)".
Page 1-M, Table 1-1. Model 5355A Specifications:
All Serials
>Change maximum Operating Temperature to 55 degrees.
2132A
>Change 40ns to 65ns under DEFINITIONS, rms jitter=.
Page 1-5. General Information:
All Serials
>Add the following paragraph after Table 1-2:
OPTION W30 (Extended Hardware Support) provides two addi¬
tional years of return-to-HP hardware-service support.
Option W30 is available only at time of purchase. Service
contracts are available from Hewlett-Packard for instruments
which did not include Option W30 at time of purchase. For
more information, contact your nearest Hewlett-Packard
Sales and Support office (offices are listed at the back of
this manual).
Advertisement
Table of Contents
