Panasonic CY-M9054EN Operating Instructions Manual page 7

Location of Controls
(Side View) a r--
2® QOOcOO
MIN MAX (MB .HdB 0* -140B ^ ^ BOH. BOOH, MIN MAX
,
/Yf^\
gLn
b«ss b/Jss gain
,
INPUT)-FRONT
GAIN
INPUT-REAR
r- POWER—n ,-REAR-SPEAKER-FRONT-
GND BATT CONT L+ L- R- R+ L+ L- R- R+
Side View (Output side)
® (|) © ® © ©
For use in a 4-channel system:
Rear Channel
Rear Channel
Rear Channel
Rear Channel
Front Channel
Front Channel
Front Channel
Front Channel
Left Side (+)
Left Side {-)
Right Side {-)
Right Side (+)
Left Side (+)
Left Side (-)
Right Side (-)
Right Side (+)
For use in a 3-channel system
(D ; Rear Channel (Bridge) (-
For use in a 2-channel system:
Rear Channel (Bridge)
(-)
: Rear Channel (Bridge)
(-)
Rear Channel (Bridge)
(+)
: Rear Channel (Bridge)
(+)
Front Channel Left Side
(+)
© : Front Channel (Bridge)
B
Front Channel Left Side
{-)
: Front Channel (Bridge) W
<© : Front Channel Right Side (-)
(ED
: Front Channel Right Side (+)
Even if the connection is bridged, both left and right channel of the input
connector should be connected, Otherwise the amplifier will not work.
Power Indicator
Lights up when the power of the cassette/CD
player connected to this unit is switched on.
Protect Indicator
Bass Level Adjust Volume (For Rear Chan¬
nels)
Used for adjusting the bass output level for rear
channels.
Lights up when the protect circuit of the amplifi¬
er is activated.
0
Input Connector (For Rear Channels)
(RCA Terminal)
For connection with the cassette/CD player's
output.
O Level Adjust Volume (For Rear Channels)
Used for adjusting the amplifier output level for
rear channel.
0 Filter Frequency Adjust Volume
Used to change the cutoff frequency of the low-
pass filter within the range of 40 to 400 Hz
(when the filter selector switch is on)
0 Filter Selector Switch
Used to activate the low-pass filter on rear
channels.
0
Bass Level Adjust Volume (For Front Chan¬
nels)
Used for adjusting the bass output level for front
channels.
0
Level Adjust Volume (For Front Channels)
Used for adjusting the amplifier output level for
front channel.
0 Input Connector (For Front Channels)
(RCA Terminal)
For connection with the cassette/CD player's
output.
0
Fuse (20AX2)
This fuse is for circuit protection.
0
Power Supply Terminal
For connection with the power supply.
0
Speaker Output Terminal
For connection with the speakers.
7