Table of Contents
Advertisement
1.3.2 Mechanical Block Self-Diagnostic Function (B Mode)
Caution:
Complete the A mode before engaging the B mode.
(1) Setting Procedure
1) | Connect (attach) a power supply (battery).
2)
Press the EJECT switch to set to the eject state.
3)
Press the "Hi-8 MP" switch on the trouble sensor and the DATE button and hold them, then set the CAM/OFF/VIDEO
switch to "VIDEO" (Hoid this state for a few seconds.) [Within 3 seconds].
4)
Close the cassette lid.
5) | The procedure ends in the eject state.
Note:
Do not close the cassette lid.
Supply reel disk
Idier plate
Cassette holder
switch
Hi-8 MP switch
Sub chassis
Fig.1-3 Hi-8 MP Switch Position
tl
< Results of self-diagnosis >
E6.
D <Vx.xx>
200x/xx/xx
* The defective items flash.
UNL.
¢ The shaded items are the tape detection switches
RST
and cassette holder switch which flash when they
are not pressed.
* See Table 1-3 for the results of diagnosis.
Cautions:
¢ Do not press any buttons other than those specified
during self-diagnosis; otherwise, it may cause a
malfunction.
* The indications in dotted lines are not covered by
the self-diagnostic functions.
* It is normal for the diagnostic procedure to end in
the eject state.
Do not close the cassette lid
thereafter.
[To release]
* Set the CAM/OFF/VIDEO switch to "OFF".
Advertisement
Table of Contents
