Table of Contents
Advertisement
Caution:
* Be careful so as not to damage the connectors (PG0202 and PG2102) between the VCA and DV circuit boards.
@ DV Circuit Board (A)
(1) Move the lower side of the DV shield (E) in the direction of the arrow and release 2 contacts.
(2) Move the upper side of the DV shield (E) in the direction of the arrow and release 2 contacts.
(3) Remove the DV shield (E) from the VCA circuit board in the direction of the arrow.
(4) Remove 1 screw holding the DV circuit board..
(5) Disconnect 1 flat cable on the DV circuit board.
(6) Remove the DV circuit board in the direction of the arrow.
mg VCA Circuit Board (B)
(7) Disconnect 1 connector and 4 flat cables on the VCA circuit board.
(8) Release 2 tabs holding the VCA circuit board.
m@ Mechanism Frame (C) and UH Mechanism (D)
(9) Remove 3 screws holding the mechanism frame.
(10) Remove 1 screw holding the cylinder shield (F).
(11) Remove 1 screw holding the mechanism shield CE (G).
Reinstallation procedure and cautions:
¢ Connect connectors PG0202 and PG2102 securely.
* Connect contacts DV shield and VCA circuit board securely.
: DV Circuit Board
: VCA Circuit Board
: Mechanism Frame
: UH Mechanism
: DV Shield
: Cylinder Shield
: Mechanism Shield CE
QONmMmogogwpY
Fig. 2-7
F2-7
Advertisement
Table of Contents
