Table of Contents
Advertisement
Before Starting Adjustment:
« The spot noise Is identified as the fine white noise that appears when the lens cap Is attached after the power Is turn on.
* Perform this adjustment only for products with which spot noise occurs. (However, there is no problem even if products
free from spot noise are adjusted.)
* After replacing the CCD image sensor or VCA circuit board (EEPROM), check whether or not spot noise occurs and then
proceed with adjustment.
Porcedure:
1) Start the MAP.
2) Refer to display 1-6.
3) Cap the lens.
4) Connect the color video monitor to video out.
5) Press F key.
Perform adjustment according to the computer display hereafter.
See "8. Error Messages" if an error message appears on the computer display.
Note:
To complete adjustment, press the [ESC] (escape) key twice to restore the MS-DOS screen and then turn off the
camera/recorder and jig.
7.7
LCD (LCD Monitor) Adjustment
Before Starting Adjustment:
* Be sure to perform this adjustment after replacing the LCD unit, components on the LCD circuit board or the VCA
circuit board (EEPROM), or initializing the EEPROM.
¢ Picture appears on the LCD monitor when the monitor is open. Perform adjustment with the LCD monitor open (SW773
on the CON circuit board set to OFF).
1) Start the MAP.
2) Refer to display 1-6.
3) Press G key.
4) Refer to display 7-1.
——
_ Display & Figs
Display 1-6
Display 7-1
MAIN MENU
LCD ADJ. MENU
MANUAL ADJUSTMENT
PROGRAM
LCD ADJUSTMENT
[A]
| DATA MAINTENANCE
[1]
FLICKER
[B]
| ADJUSTMENT
[ESC] RETURN TO MENU
[C]
AUTO FOCUS
Please select [1] or [ESC]
[D}
| VCR ADJUSTMENT
[E]
STABILIZER
[F]
SPOT NOISE
[IG]
LeD
[H] | COLOR EVE
[ESC] END
Please select [A] - [H] or [ESC]
F3-14
Advertisement
Table of Contents
