Table of Contents
Advertisement
" BE=2520
@ Make sure. the display is filled with zeroes, then release
the keys.
© Press a numeral. key to enter either of the. following
codes, then press a validation function key* (DEPOSIT,
CASH OUT, CASH IN, CASH CHECK, MISC1, MISC2,
MISC3, MISC4).
Full validation print including the
amount
Validation print with the amount not
printed -
oa
Validation
@
Make. 'sure the entered: code is printed on the journal,
then turn the mode switch back to "REG" position,
Notes: 1. If the [DUP] key
is used, the printing format
depends upon how each validation function. key
is set.
2. If the machine is programmed
for double cycle
printing, the printout
on the journal occurs
in
such a format that no amount is printed.
3. When the totalizers are updated, the amount is
not updated, but the number
of times alone is
updated,
3-11. (MRS11)
Selection
of
resettable
or
no-
resettable consecutive number
@ Turn power OFF,
® Set the mode switch to "2" position.
_
@ While pressing the numeral key [0] and
key at the same time, turn on the power switch.
@
Make sure the display is filled with zeroes, the release
the keys.
®@® Press a numeral
key to énter either of the following
two codes, then pres the ACCT
[ACCT # | key.
Setting
1XXXX
Resettable consecutive suine:
2XXXKX
Non-resetable consecutive number
Note. X X XX:
Lower 4-digit of setting code is a pre-
determined consecutive number.
Setting code
(5 digit)
Rascal #
@ Make sure the entered code is' printed on the journal,
then turn the mode switch back to "REG" position. ©
Note: The consécutive numbérs is to be réset with the
following resetting operation if the machine is pro-
grammed for tesettable consecutive number:
©
Batch totalizer resetting |
@ Down totalizer resetting"
PROCEDURE:
1. Turn the power switch off.
2. Set the mode switch to the Z position.
CASH-IN]|
key, turn power on.
4. Release
the keys after confirming
that the display
is
showing all zero's.
ENTRY
OF
PARAMETERS:
1. Enter the appropriate entry code as follows:
TOTAL PRINT
KEY ENTRY
ENABLE
DISABLE
Code
.
;
Acct #
(1 digit)
PROCEDURE:
1. Turn power off.
2. Set the mode switch to the " Z.'' position.
3. Push the [1] and the
keys at the same time,
then turn the power switch from off to on.
4. Préss the 0, 1, or 2 key to select the function followed
by the appropriate V/F key as follows:
Entry data
Advertisement
Table of Contents
