Table of Contents
Advertisement
5.17.2
Configuration
To configure the CoRe function (only displayed if
enabled in the Setup Menu), follow this procedure:
1. Call up the Main Menu.
2. Select
.
3. Select
.
4. Select Connected Repair [CoRe]. The display shows
three selection options:
+
Settings: to configure the connection to the CoRe
server. The data to enter is as follows:
$
Host address: is the IP address of the CoRe
server.
$
Host port: is the server port used for the
connection, typically the port number is set to
59487 by default, but it is possible to check this
parameter on the CoRe server in the Settings -
Computer Overview section.
$
Password: is the password (Interface password)
set during the installation of the CoRe server.
5. Confirm the entered data with
"
ACS 663 will try to connect to the CoRe server to check
that all parameters entered are correct.
5.17.3
Operation
To use the CoRe function:
+
Select available A/C task: to select and perform A/C
services previously registered at CoRe server level.
After connecting the ACS 663 to the CoRe server
using the settings described above, it is possible
through this item to select one of the available A/C
services and perform it on the desired vehicle. Once
the A/C service is selected and performed, the
ACS 663 will send a report to the CoRe server that
will automatically save the result and all data related
to it.
+
Create new A/C task: to create an A/C service from
the ACS 663 and assign an Air Conditioning Service
to one of the active vehicles in the workshop.
Selecting this item will display the list of all active
vehicles in the workshop and registered on the CoRe
server regardless of whether or not a specific A/C
service has been requested. When the vehicle is
selected, the ACS 663 will send a special command
to the CoRe server so that the latter registers that
an A/C service is being performed on the selected
vehicle. At the end of the A/C service, a detailed
report will be sent to the CoRe server that will save
it and make it available for displaying or printing.
Robert Bosch GmbH
6.
6.1
i
After selecting any service function, it is possible to
enter information about the vehicle in order to allow
printing the automatically compiled final receipt.
The display shows
Enter vehicle data
Make: ____________________________
Model: ___________________________
Plate: ___________________________
VIN: _____________________________
MILEAGE: _________________________
Operator: ________________________
i
Use the arrow buttons to move between the rows
and the multi touch keypad to enter the text.
.
1. Select
i
This page also shows the Database icon to allow
the user to select a vehicle from the European or
Personal Database if available. If this selection is
made, the BRAND and MODEL fields will be filled
out automatically.
!
Make sure to comply with the standards regarding
the protection of personal data in your state.
Initial settings | ACS 663 | 57
Instructions for use
Entering service data
to save the data for the print report.
SP00D00616
en
|
2019-11-08
Advertisement
Table of Contents
