Mitsubishi Electric unisen 154 Series Basic Owner's Manual page 21

3. TV Features 21
iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii
Photos and Moving Video
as Composite Video
Connect the camera to the TV using a composite video
cable and control the slide show or movie through the
camera. The display resolution will be standard-defini-
tion (480i).
1, Refer to the owner's manual supplied with the
camera for instructions needed for this setup.
Set the camera's output signal type to NTSC and
put the camera into playback mode.
3, With the camera still turned on, connect your digital
camera's composite video cable (usually yellow) to
the TV's YiVmDEOjack. To hear audio, connect the
camera's audio output cable to the AUDmOL jack.
The Sleep Timer turns the TV off after the length of time
you set. To set the TV to turn on at a certain time of
day, see the Setup > Timer menu on page 27,
Setting the Smeep Timer
1, Press SLEER
°
Press SLEEP additional times to increase the time in
30-minute increments up to the maximum of 120
minutes.
Press EXITor wait five seconds without pressing any
keys for the message to clear,
Viewing or Changing the Smeep Timer
1, Press SLEEP to display the on-screen message.
Press SLEEP additional times to change the time
before the TV powers off. To cancel the Sleep
Timer, press SLEEP repeatedly until OFF is dis-
played.
Camera connection using a composite video came
4, When the New Device Found screen displays,
assign the name Camcorder.
Press EXITto close the New Device Found screen.
Highlight the icon for the camera input and press
ENTER.
8_
If viewing photos, advance through the images
manually or set the camera to advance automati-
cally.
If viewing photos, control the slideshow from the
camera. Advance through the images manually or
check if the camera can advance automatically.
For assistance ca((1(800) 332-2119