Mitsubishi Electric unisen 154 Series Basic Owner's Manual page 6

6
Wall=iVlounting
To order a wall-mount kit, please contact Peer-
less Industries, Inc. at (800) 473-3753 or visit
www.peerlessmounts.com. Order wall-mount kit model
ST650.
Stand Remova_ Prior to WaHoMounting
To order a wall-mount kit from Mitsubishi Digital Elec-
tronics America, Inc., please visit www.mitsuparts.com
or call (800) 553-7278.
Complete installation instructions are included with the kit.
Note
• 55=inch TV: Remove the factory-installed stand prior to wall-mounting.
40= or 46=inch TV: If you installed the stand for table-top use, follow these instructions to remove it prior
to wall-mounting the TV.
1, Disconnect the TV's AC power cord from the AC
power outlet.
Spread the protective sheet that was wrapped
around the TV on a flat, even surface, such as a
sturdy table. The protective sheet will help prevent
damage to the display.
iMPORTANT: To avoid damaging the screen,
make sure there are no foreign objects under or
on top of the protective sheet.
3, Position one person on each side of the TV (left and
right sides). Have each person firmly grasp their side
of the TV and gently place it face down on the pro-
tective sheet with the display stand hanging over the
edge of the table. See the illustration to the right.
4, Use a magnetic philips screwdriver to remove the
stand screws from the recessed holes (see illustra-
tion to right). Note: A regular screwdriver can be
used with a separate magnetic pick-up tool.
While one person holds the TV with both hands,
have the other person grasp the stand (see illustra-
tion to the right) and remove the stand by pulling it
away from the TV in the direction of the large arrow
shown in both illustrations.
Protective
sheet
TV
\
Stand __
Table
f
55-inch TVs
(6 screws)
Protective
Sheet
40- and 46-inch TVs _
(4 screws)
J
Pull stand
to remove.
For assistance call 1(800) 332-2119