Setting The Head Unit - Pioneer DEQ-7200 Owner's Manual

When the audio signal is not input for
more than 20 seconds, the display
automatically switches to the demo mode.
The dispaly is restored when an audio
signal is input to this unit.
Setting the Head Unit
Parts Identification
Fig 1
[1] Volume buttons
[3] Display
Fig. 2
[17] Sound clip indicator
When this unit is connected to the head
unit, the volume, balance and fader can be
adjusted with this unit. Before operating
this unit, set the head unit as follows.
1. Press the (—) side of buttons [1] to set
the volume of the unit to "VOL 0".
2. Set the volume of the head unit to
"VOL 23".
3. Set the fader and balance of the head
unit to center position.
¢ To adjust the volume, fader and balance
on the head unit, refer to the Owner's
Manual that accompanies the head unit.
No te:
When the head unit volume is excessive
(excessive input to the unit), "CLIP" [17]
will be indicated on the display as a
warning. In this case, turn the volume
on the head unit down to the point
where "CLIP" is no longer displayed.
When you feel a distortion in the sound
even though "CLIP" is not indicated on
the display, turn the volume on the
head unit down.
The volume's set point is not indicated
on the display when you adjust the
volume on the head unit by tuning the
volume control. In this case, set the
volume control on the head unit to the
position illustrated below, in accordance
with step 2. (Fig. 13)
Adjusting
range
aN — qa
Fig. 13