Table of Contents
Advertisement
Fine tuning of the Position
(Fader/Balance)
After choosing the position using the
position selector function, it is possible to
fine tune the sound image positioning by
adjusting the fader and balance controls.
e
The fine tuning can be applied
independently for each position.
e
The condition after fine tuning will be
stored in memory as the setting for
each position. The next time the
position is recalled, the setting after fine
tuning will be recalled.
1. Press button [4] to switch to the fader/
balance mode.
Each press of button changes the mode
as shown below.
| Fader/balance mode
14
Press (&) or (W) side of buttons [5] to
adjust the volume balance between the
front and rear (fader control).
(Numeric display [15] shows "F25 —
R25":)
Press (~@) or
(®) side of buttons [6] to
adjust the balance between the left and
right (balance contro)).
(Numeric display [15] shows "L25 —
R25")
Resetting the Position
|
The sound image positioning after fine
tuning can be reset to the initial conditions
of the fader and balance control.
Press and hold button [7] for more than 2
seconds.
|
A short beep sound is generated and the
fader/balance are initialized.
Note:
e
The fader control is not used with a 2-
speaker system. Set the fader to the
center position.
¢
If your system is configured so that it
does not use either the front or rear
output of this unit, the position selector
and fader will not function properly.
lf you system is a 4-speaker system
which is configured without using either
the front or rear output of this unit, the
volume balance between the front and
rear speakers should be adjusted on the
head unit.
Advertisement
Table of Contents
