Advertisement
DEQG-7200
Adjusting the Volume
Parts identification
Fig. 3
{1}
Volume buttons
[3]
Display
Fig.4
|
{15} Numeric display
Pressing the (+) side of buttons [1]
increases the volume, while the (—} side of
|
buttons [1] decreases it.
(Numeric display [15] shows "VOL 0 —
VOL 30".)
Note:
*
Always keep the volume inside the car
at a level that allows you to hear outside
sounds.
Fine tuning of the Position
(Fader/Balance)
After choosing the position using the
.
position selector function, it is possible to
fine tune the sound image positioning by
adjusting the fader and balance controls.
+
The fine tuning can be applied
independently for each position.
*
The condition after fine tuning will be
stored in memory as the setting for
each position. The next time the
position is recalled, the setting after fine
tuning will be recalled.
1. Press button [4] to switch to the fader/ —
'balance mode.
._.
Each press of button changes the mode
as shown below.
Fader/balance modé.
Nuance contro! mode
Graphic equalizer mode
Adjusting the Listening
Position
One of the conditions for reproduction of
more natural music is to "clearly define the
sound image positioning (listen to music at
the center of the sound field)".
The position selector function
appropriately adjusts the delay time and
level of the sound from each speaker
according to the seat position(s) and the
number of people in the car and allows to
recall this setting with a single button
operation. This makes the listener(s)
possible to obtain natural acoustic
property regardless of the seat positions.
Parts Identification
Fig. 3
[3]
Display
[4]
Mode shift button
{5)
Fader control buttons
{6]
Balance control buttons
{7]
Position selector button
Fig. 4
[13] Operation dispiay
[15] Numeric display
[16] Position indicator
2. Press (A) or (W) side of buttons [5] to
adjust the volume balance between the
front and rear (fader control).
(Numeric display [15] shows "F25 —
R25",)
|
:
3. Press (<4) or (>) side of buttons [6] to
adjust the balance between the left and
right (balance control).
(Numeric display [15] shows "L25 —
R25".)
Setting the Listening Position
(Position selector)
Set the listening position according to the
position(s) of the listener(s).
Press button [7].
Each press of button changes the listening
positions [16] as follows.
OFF
Front/left
Front/right
oz
13;
ai
ob
(CH
a m a n
CC
Sy} 8
ALL
Front
Resetting the Position
The sound image positioning after fine
tuning can be reset to the initial conditions
_ of the fader and balance control.
Press and hold button [7] for more than 2
seconds.
.
a
A short beep sound is generated and the
fader/balance are initialized.
*
Only the currently selected position can
be reset.
Note:
*
The fader control is not used with a 2-
- speaker system. Set the fader to the
center position.
*
lf your system is configured so that it
does not-use either the front.or rear
output of this unit, the position selector
and fader will not function properly.
'If you system is a 4-speaker system
which is configured without using either
the front or rear output of this unit, the
volume balance between the front and
rear speakers should be adjusted on the
nead unit.
Advertisement
