Advertisement
Caution: Observe the proper
battery polarity orientation when
installing batteries. Incorrect
positioning can damage both the
batteries and the unit.
a. Slide down the Battery Compartment
Cover.
b. Install the rechargeable battery pack
by following the orientation as shown
In Fgure 3 (the arrow Is showing and
pointing upward.)
c. Replace the Battery Compartment
Cover. See Fgure 4.
Important
Read these Safety Warnings before you
charge the batteries. When placing the
PMR In the charger, use only the
power supplies listed in the user
instructions supplied with the PMR. Don't
try to recharge non-rechargeable
batteries.Make sure the battery
compartment cover is securely locked
in place when you are charging the
batteries. Dispose of used batteries
safely and in a way that will not harm
the environment- never try to bum them
or put them anywhere, they could get
burnt or punctured. Don't leave dead
batteries in your PMR units. They might
leak if you do.
Charging the battery pack
a. Insert the small plug on the end of
the mains adaptor into the Power-in
Connection Jack at the back of the
desktop charger.
b. Plug the mains adaptor into a 240V
AC, 50Hz main socket with the switch
on the socket set to OFF.
c. Switch ON the main socket.
The PMR must be charged using the
mains adaptor provided. Using any
other adaptor will result in non-
compliance with EN60950-1 and will
invalidate any approvals & warranty.
d. Place the PMR units in the charge
cradle in an upright position and facing
outward. The Charge LED indicators will
light up.
e. It takes about 10 hours to fully
recharge the batteries if they are
completely run down. New batteries
take up to 14 hours to fully charge.
f. Charging the battery pack (using
adaptor) Lift the charge socket cover
located on the right side of the handset.
Important: Always turn off the PMR
units when harging.This will shorten the
charging time.
Q
Pi
Insert the round connector of the 9.0V
DC/200nnA adaptor into the charge jack.
Advertisement
