Advertisement
-time." While you arespeaking, you can
a number on the LCD Screen. At the
not receive a transmission. The PMR is
highest level, the units wll pickup
an open-license band. Always identify
softer noise (including background
yourself when transmitting on the same
noise); at the lowest level, it will pick
channel.
up only quite loud noise.
Transmitting (sending a speech)
__
a. Press the MENU button 4
i
a. Press and hold the PTT
times, "VOX" will be displayed
(push to talk) button to transmit
and "OP flashes on the LCD
your voice. "TXwill be displayed
Screen,
on the LCD Screen.
a
b.Press the UP button to set
I
b. Hold the unit in a vertical
H
the VOX sensitvity level (the
position with the MIC
maximum level is''3 ".) To
(Microphone) 5 cm away from the
deactivate the VOX function, press the
mouth. While holding the PTT button,
DOWN button until "OF" appears on
speak Into the MIC (microphone) in a
the LCD Screen, c.Press the PTT button
normal tone of voice.
to confirm your setting. "VOX" will
c. Release the PTT button when you
steadily appear on the LCD Screen as
have finished transmitting.
along as the VOX feature is activated.
Monitor
You can use the Monitor feature to
check for weak signals on the current
a.Press and hold the MENU
and DOWN buttons at the
same time. "RX" wili be
dispiayed on the LCD Screen.
Your PMR will pick up
signals on the current channel,
including background noise,
b. Press the PTT button to stop the
channel monitoring.
Setting the VOX (Voice Activated)
Sensitivity
In VOX mode, the PMR will transmit
a signal only when it is activated by
your voice or other sounds around
you. The unit will transmit further for 2
seconds even if you stop talking. The
level of VOX sensitivity is shown by
channel
s
VOX operation is not recommended if
the PMR will be used in a noisy or windy
environment.
Vibrator and Caii aiert
Your FX-117 can alert you to incoming
signal by emitting an audible call tone
and vibration signal.
Caii-Ring tone
You can send a Call-ring tone to other
PMR users to give an alert that you want
to communicate with them.
Press the CALL button Yu will
hear a ring tone for about two
seconds: 'TXappears on the
LCD Screen. Any other units
within the transmitting range
and turned to the same
and sub-channel (if applicable)
will hear the Call-ring tone.
channel
7
Advertisement
