Advertisement
54
Miceye) o)(=tyareyeltiare melelie (=
Symptom
Cause
Remedy
Basic
operation
The tape is rejected after being
loaded.
The tape does not move.
The cassette is inserted incorrectly.
For 4 seconds after the power is
_turned on, the buttons do not function.
The PAUSE button is activated. (The It
| indicator lights.)
' The tape is wound completely.
Insert the cassette correctly. (page 16)
Wait until the blinking of the Wl indicator
goes off and then try again.
Press PAUSE to release pause.
Press <4 or [Ki button to rewind.
Sound is not heard.
Incorrect connections.
i Incorrect operation of the connected.
' amplifier.
Recording cannot be made.
| The safety tab of the cassette is open.
Incorrect position of the INPUT
selector.
| The digital copy prohibit signal exists in
the source signal input to the digital
, input jack.
The recording level i is S turned down
completely.
Sub
code
operation
The CAUTION indicator lights, and
no button does function.
Moisture condenses inside the unit.
Defective or damaged cassette is
inserted.
; Connect properly. (pages 14-15)
' Operate the amplifier as required by
the deck operation. (Refer to the
operating in
instructions of the amplifier. ae
: Close the tab of the cassette. (page 16)
Set the INPUT selector correctly.
Set it to DIGITAL to record sound from
the equipment connected to the
COAXIAL IN or OPTICAL IN jacks.
Set it to ANALOG to record sound
from the equipment connected to the
LINE IN jacks.
' Connect the source equipment to
to the
' LINE
IN jacks.
Adjust the recording level by using the
_ REC LEVEL controls. (page 20)
Leave the unit as is, then turn on the
power. (See page 5.) _
Remove the cassette.
J Sub code cannot be written.
| The safety tab of the cassette is open.
Close the tab of the cassette. (page 1 6)
| Start ID cannot be written during
recording.
| Anew start ID cannot be written within
9 seconds (18 seconds in the long-
play mode) from the end of another
| startID.
Leave at least 9 seconds (18 seconds
in the long-play mode) from the end of
another start ID.
Search function does not activate
during playback.
The start ID is not written correctly.
Erase it (page 30), and then write it
again.
The portion between the end of a start
\D code and the beginning of the
following start ID is less than 9
seconds (18 seconds in the long-play
| mode) long.
When writing the start IDs manually,
write so that the intervals between
them are more than 9 seconds
(18 seconds in the long-play mode).
The selected program number does
not exist on the tape.
Use the RENUMBER button to
| rearrange the program numbers. (page
The program numbers are out of order.
32)
Advertisement
