Table of Contents
Advertisement
Troubleshooting
Use the Troubleshooting Chart to remedy certain symptoms. Find the "Symptom" concerned in the left-hand
column of the table, and take the "Suggested remedial action" in the right-hand column.
Always make sure that you have conducted the basic checks before consulting the Table.
Symptoms related to personal computer monitor
@ Nothing
at all appears
on
the| æ First, check whether the monitor is a PC/AT compatible monitor.
monitor screen or the "NO SIGNAL"
or other warning display appears.
è When nothing at all appears, check the supply voltage, connecting
cables (for disconnections) and monitor unit settings.
e Some monitors have their own self-diagnosis functions.
If you feel
that the monitor unit is responsible for the trouble, refer to the manual
accompanying the monitor, and check the adjustment and test
methods.
è if you still cannot trace the cause of the problem, try replacing the
troubled monitor with a monitor whose operation is trouble-free if
such a monitor is at hand.
@ The display keeps running off the; e Check the monitor's resolution setting.
monitor screen.
This product's default resolution setting is 1152 x 870, and its default
refresh rate setting is 75 Hz.
These settings may not display properly on some monitors.
Refer to
the manual accompanying the monitor, and check its available
resolution settings.
è If you still cannot trace the cause of the problem, refer to the above
symptom (Nothing at all appears on the monitor screen or the "NO
SIGNAL" or other warning display appears), and check whether the
monitor is to blame for the problem.
R The display on the monitor screen|
è Check whether the VGA cable at the main unit's rear has been
ceases to change when the main|
connected the wrong way round.
unit is started up.
This product provides the appropriate monitor output signals when
the system is started up and when the editing application program is
run.
Since the VGA cable supplied with this product serves to supply
these two outputs to the monitor as a single output, one of the VGA
connectors is identified as the up one and the other as the down one.
Connect the VGA connector to the main unit's rear panel in such a
way that the protruding splitter cable for the monitor is connected to
the up connector.
.
For further details on the connections, refer to the main unit's rear
panel connection diagram. (See page 12)
Advertisement
Table of Contents
