DeWalt DCMWP500 Manual page 59


DANGER: Rotating blades can cause serious injury.
To prevent serious injury, turn unit off and remove safety
key and battery pack when unattended, or when charging,
cleaning, servicing, transporting, lifting, or storing mower.
1. Insert safety key 6 into the key slot
handle 4 , until it is fully seated inside of the key slot
shown in Fig. T.
2. The mower is now operational.
LED Dashboard Indicators (Fig. A, U)
The control panel contains the state of charge indicator,
12
load meter indicator, temperature indicator, handle folding
indicator, blade sharpening indicator and reset button.
State of Charge Indicator (Fig. U)
The DCMWP500 and DCMWSP550 are equipped with a state
of charge indicator. This will display the current level of charge
in the battery during use. It does not indicate tool functionality
and is subject to variation based on product components,
temperature and end-user application.
• The state of charge indicator LEDs
indicating the percent of charge in the battery.
• When all 5 state of charge indicator LEDs
battery is fully charged.
• When one state of charge indicator LED
charge is low and then it will flash when the battery
is discharged. Remove the battery and charge it.
State of Charge Indicator LED Status
LEVEL OF CHARGE
100% ‑ 85%
70% ‑ 85%
50% ‑ 70%
25% ‑ 50%
≤25%
Low battery shutdown
50 , located on the main
50 as
18 will illuminate,
18 illuminate, the
illuminates,
18
CHARGE INDICATOR
LED COLOR
White
White
White
White
White
White and blinking
Handle Folding Indicator (Fig. U)
The handle folding indicator
single touch handle is not engaged in the operating
1
position when the safety key
installed, and the bail handle
folding indicator 15 , refer to the Raise the Single Touch
Handle section in this manual.
Cutting Load Meter Indicator (Fig. U)
The cutting load meter indicator
yellow or red when mowing.
• White indicates a low cutting load.
• Yellow indicates a medium cutting load.
• Red indicates a high cutting load. Runtime will be reduced if
there is a prolonged high load while mowing.
Overheat Indicator (Fig. U)
• The overheat indicator
blink when the battery or motor is overloaded during
operation.
• The overheat indicator
when the module has reached a high temperature.
• To clear the overheat indicator
mower to cool down. When cooled, restart the mower and
resume cutting with the mower deck set higher.
Blade Sharpening Indicator (Fig. U)
The blade sharpening indicator
blades need service. Sharpen or replace the blades, refer to the
Blade Sharpening section in this manual.
Blade Reset Button (Fig. U)
nOTE: Ensure the battery pack
are installed before attempting to reset.
To clear the blade sharpening indicator
dashboard by pulling and holding the bail handle
12
the main handle 4 . Press and hold the blade reset button
until the blade sharpening indicator
will illuminate when the
15
6 and battery pack 26 are
8 is pulled. To clear the handle
14 will illuminate white,
13 will illuminate amber and then
13 will illuminate red and then blink
13 , allow the battery and
16 will illuminate when the
26 and safety key 6
, power on the LED
16
16 turns off.
EnGLIsh
to
8
17
57