Logitech BRIO 501 Setup Manual page 27

HEADPHONES LIGHT INDICATOR
White
Connectivity
Red
Note:
- User-triggered behaviors, such as Bluetooth
behavior is completed
CHARGING
To conserve battery life, headphones
automatically power off after 30 minutes
without usage.
Sleep timer could be adjusted in Logi Tune.
The LED light on the headphones will blink slowly
in RED when the battery is low.
Charging via USB cable
1 Plug one end of the cable to the USB-C port
on the bottom of the earcup and the other end
into the USB-C charging port on your computer
2 The LED light will start breathing white when
charging
3 The LED light will turn solid white when
fully charged
– 2 hours will fully charge the battery
– 5 minutes will give you 1 hour of playback
4 The headphones can be used with Bluetooth
paired while charging
Category
Power Battery charging
Battery fully charged
Bluetooth
Bluetooth
Calls
Incoming call
Calls
Power Low battery (< 10%)
Factory reset
pairing, will be prioritized then revert back to its previous status once the
®
®
Status
Power ON Turn solid white and then dim
pairing
®
connected Turn solid white and then dim
®
Active call
Mute
Fast blink from red to white for
three times then LED turn off
Light
Breathing
Solid and then off
Fast blinking
Solid
Slow blinking
Solid
Slow blinking
8 English