Husqvarna BGS 250 Operator's Manual page 15

1. Push the OFF button to stop the motor.
2. Keep the tool plate against the surface until it fully
stops. Make sure that the tool plate does not rotate
before you lift up the front.
CAUTION:
asphalt, paint or equivalent material, lift
up the front of the product slightly when
the tool plate stops. The product can
attach to the adhesive surface if it is not
lifted.
3. Pull out the power plug.
To stop the product
CAUTION:
the surface when you stop the motor. The
tool plate rotates for a while after the motor
stops. Much of the dust can blow off into the
air and the surface can be damaged.
1. Push the OFF button to stop the motor.
2. Keep the tool plate against the surface until it fully
stops. Make sure that the tool plate does not rotate
before you lift up the front.
CAUTION:
asphalt, paint or equivalent material, lift
up the front of the product slightly when
2363 - 002 - 12.03.2024
If you grind adhesive
Do not lift the tool plate from
If you grind adhesive
the tool plate stops. The product can
attach to the adhesive surface if it is not
lifted.
3. Pull out the power plug.
To change the position of the wheels
There are 2 possible wheel positions in the frame.
The rear hole (A) is used during standard grinding
and polishing operation. The front hole (B) is used to
decrease the grinding pressure.
A
B
1. Remove the bolts, the washers and the wheel from
the frame.
2. Install in the opposite sequence in the correct hole in
the frame.
3. Do the same procedure on the opposite side of the
product.
To connect a dust extractor
Use a Husqvarna dust extractor system with minimum
HEPA 13 filter.
15