No Turn On - Motorola MotoRAZR maxx V6 Manual

Hide thumbs Also See for MotoRAZR maxx V6:
Table of Contents

Advertisement

Motorola GmbH, Mobile Devices, CSS Center
Title:
Troubleshooting-Guide MotoRAZR maxx V6

No turn on

Verify if radio doesn't turn on (assembled with display). If it does, but doesn't enumerate via
EMU-Connector at RSD/RepairStudio there should be a problem with the USB connection.
In some cases a 1FF SW reflash in
to radio while "*" and "#" are pressed) can fix this issue.
-
If not, visually check EMU-Connector
on contacts, bad soldered pins or solder shorts
-
Check
D5002/C5001/C5002
-
If ok, change ATLAS IC
If the problem remains, it could be a problem with the ARGON IC
authorized level 4 service center.
Repair Support Information
FORCED FLASH MODE
J5000
for mechanical defects or contamination
for internal short to GND,
U3000
Figure 29
© Copyright 2003-2007 Motorola Inc. All Rights reserved.
Motorola internal use
Doc. No:
TSG_3G_V6
Version:
1.0
Date:
23.07.2007
Page:
27 / 40
(by connecting EMU-Connector
R3650/R3651
(22 Ohm)
U1000
– forward to an

Advertisement

Table of Contents
loading

Table of Contents