Table of Contents
Advertisement
PROGRAMMED EDITING USING THE REMOTE CONTROL
oa
a nae ade nada
a ead
gat dno 8d
ARRAROEN
S $
tl Load e a blank tape ir
into 'the VCR, then set it to
i
$
recording pause mode.
ved
Press the RUN button on the remote control. The
editing will start automatically.
The tape in the camcorder is rewound, and
segments A, C and B will be searched then played
back in the selected order.
@ The VCR will switch between recording and
recording pause mode to match playback on the
camcorder.
@ if the DATA ON SCREEN button has been
pressed, the on-screen display will appear while a
segment is searched, however it will disappear
while the segment is being copied. __
;
n
a
a
a
a
a a a
;
a
a
When programmed editing is finished, the
i
camcorder is switched to stop mode, and the VCR to
recording pause mode.
You can then, erase the programmed editing
settings and programme another 8 segments to be
edited to the same tape in the VCR, or load another
blank tape in the VCR and simply press the RUN
button to copy the same 8 segments.
PEPEE
ETT
a
a
ea
a
al
p= Notes:
@ After editing, the settings are not erased until the
cassette tape is unloaded, or the POWER switch on
the camcorder set to "OFF".
@ For more details on how to operate the VCR, please
refer to its instruction manual.
@ To stop programmed editing, press the STOP
button, then stop the VCR.
Tape recorded using the programmed editing
function ASi
17
Erasing, changing programmed editing settings
To change a segment setting, first erase it, then
programme the new setting.
pe ka
n n n
la
a
a a
n m m l in n ae
1
Rewind (or advance) the tape to the segment to
cancel, then start playback.
_ he programme number will start flashing.
f
Press the CANCEL button while the programme
number is flashing.
The programme number will flash rapidly for a few
seconds then disappear.
The settings corresponding to that programme
number are now erased.
f onon EAD
NE
ENA EAA
ee AEE
AA
8
AAPOR
OE
A
A
A AAAA AA
ATAT
T
A
AAGE
A
GAA
AA
A,
tÆ Notes:
@ When one segment setting is erased, its number will
stay available, if another segment is programmed, it
will be assigned the lowest available number.
@ To erase all the settings, unload the cassette tape or
set the POWER switch to "OFF".
CANCEL
De
Sen
non
PaA
ne
ba!
E About programmed editing and LANC
connections
Once the programmed editing is completed, set the
POWER switch on the camcorder to "OFF", then
disconnect the LANC cable.
Advertisement
Table of Contents
