Sanyo VM-EX26P Instruction Manual page 6

PREPARATION
AC adaptor / charger Holding the camcorder
The AC adaptor/charger is used to power the camcorder
indoors, where an AC outlet is available. It is also used to
recharge your battery pack(s).
The supplied AC adaptor/charger can be used in any
country where the standard voltage is between 100 V
and 240 V AC. In countries where a differently shaped
plug is used, a plug adaptor must be used. (See your
Sanyo dealer for details.)
fama a a ae aaa eae eee a
1 Connect the DC connecting cord from the DC output
¢ terminal on the AC adaptor/charger to the DC input
„ t e r m i n a l on the back of the camcorder, |
2 Plug the AC adaptor/charger power cord into an AC
outlet.
ee
afialeaCale ae laeaCalls a ere Telefe ele leTey
7
ae i a a
02> Note: For this product use the supplied AC adaptor/
charger (conforming to the EIA Japanese standard,
with a unified polarity type plug). Use of another AC
adaptor/charger may cause trouble.
A: Keep your feet slightly apart, and the upper arms close
to the body. Hold the camcorder horizontally. When
possible rest your elbows on a table, or your back on a
wall, etc. for more stability.
B: Raise the viewfinder, for a comfortable low angle
recording position.
The viewfinder can be raised up to about 75°.
C: Use a tripod for jitter-free pictures.
Mi Use the grip belt to carry the camcorder
Holding it as shown in the illustration below might damage
the camcorder or some of its components.
Remove the cassette tape when the unit is not being used.