Playback; Eee Eens - Sanyo VM-EX26P Instruction Manual

The camcorder can be used to play back a recorded tape
and view it on a TV receiver.
For playback, a stable power supply to the camcorder is
necessary, it is recommended to use the AC adaptor/
charger. (See page 5.)
Load the recorded tape into the camcorder, then set
POWER switch to "PLAYER".
@ Press the PLAY button to start playoack.
@ Press the STILL button for a still picture. Press the
STILL button again to resume playback.
Press the STOP button to stop playback.
@ Press the REW button to rewind the tape.
@ Press the FF button to advance the tape.
To stop the tape, press the STOP button.
@ While the tape is being rewound or advanced, press
and hold the REW or FF button to watch the picture
playback.
Release the REW or FF button to resume normal tape
rewind or advance.
@ During tape playback, press and hold the REW or FF
button to watch the picture playback.
Release the REW or FF button to resume normal
playback.
@ During still picture playback, press and hold the
SCENE SEARCH (-—) or (+) button to watch a reverse or
forward picture playback.
Release the SCENE SEARCH button to resume normal
still picture playback.
t Notes:
@ The sound is muted during playback modes other
than normal playback.
@ During reverse picture playback there will be some
noise bands in the picture, this is normal and does
not indicate a malfunction.
@ If still picture playback continues for more than 5
minutes, the unit is switched to stop mode to prevent
the tape from being damaged.
Frame Advance (The remote control only)
During still picture playback, press the F.ADV button to
advance the picture one frame at a time. Press the PLAY
button again to resume playback.
18
PLAYBACK
Slow Motion (The remote control only)
During playback or still picture playback, press the SLOW
button to start slow motion playback. Press the PLAY
button to resume playback, or press the STILL button to
resume still picture playback.
If noise bars are visible during slow motion playback,
press the SCENE SEARCH (+) or (—) button repeatedly
until corrected.