Makita 7104L Instruction Manual page 13

ACCESSORIES
CAUTION :
These accessories
or
attachments are recommended
for
use with your Makita tool specified in this
manual. The use of any other accessories or attachments might present a risk
of
injury t o persons.
The accessories or attachments should be used only i n the proper and intended manner.
791 084-6
791088-8
*791174-5
0
Cutter chain
Part
NO.
I
Width
21
m m
(13/16")
24 mm (15/16")
30
m m
(1-3/16")
791085-4
I
1 5
m m
(5/8")
791086-2
I
16.5
mm
(21/32")
791087-0
I
1 8
m m
(11/16")
- -
I
*
When using a cutter chain 30 m m (1-3/16"),
remove the standard-equipped chain bar and
sprocket, and install the chain bar for 30 mm
(1-3/16") and sprocket for 30
m m
(1-3/16").
0
Chain bar
for 30 mm (1-3/16")
Part No. 122235-4
T o remove the standard-equipped chain bar,
loosen the hex bolt securing the chain bar.
Then remove the hex bolt, spring washer, flat
washer and chian bar. Remove the adjusting
screw
from
the chain bar. To install the chain
bar for 30
m m
(1-3/16"), first install the adjust-
ing screw on the chain bar for 30 mm (1-3/16").
Then install the chain bar using the hex bolt,
spring washer and flat washer.
0
Sprocket 4 for 30 mm (1-3/16")
Part
No.
221502-5
To remove the standard-equipped sprocket, in-
sert a slotted screwdriver as shown in the figure
to lock the sprocket. Loosen the hex nut secur-
ing the sprocket and then remove the hex nut,
spring washer, flat washer, ring 1 5 and sprocket.
To install the sprocket for 3 0 " (1-3/16"),
mount the sprocket onto the spindle with the
round hole side facing in. Then secure using the
spring washer, flat washer and hex nut. The
ring 1 5 is not necessary when securing the
sprocket for 30 mm (1 -3/16").
0
Sharpening holder assembly
Part No. 123028-2
0
Wrench 13-17
Part
No.
781204-0
0
Oil supply (100 cc)
Part No. 181117-9
Hex nut
I
13