Makita 7104L Instruction Manual page 9

Push down the right-hand grip while rais-
ing the left-hand grip. Make sure t h a t the
adjusting hex bolt slips into place securely.
Loosen the hex n u t securing the adjusting
hex bolt. Turn the adjusting hex bolt until
the cutter chain reaches the desired posi-
tion, then tighten the hex nut.
I
Adjusting hex bolt
for No. 1 set
Dosition
I -
WARNING:
When using pressure to t u r n the adjusting hex bolt or hex n u t , be careful not to allow the
adjusting hex bolt to slip off the set position.
To bring the cutter chain back t o the perpendicular (original) position, pull the lever (C)
toward you while pressing down
on
the right-hand grip and slightly raising the left-hand
grip and move the cutter chain back to its original position.
When cutting a hole, first use the perpen-
dicular position, then No. 1 set position
and finally No. 2 set position. Always
safely
hook
the tool head back onto the
hook when changing the cutter chain
position.
I
9